- PROGRAMMABLE LOGIC CONTROLLER
- MECHANICAL
- Thermal Lab
- Robotics Lab
- Fluid Mechanics Lab
- Refrigeration and Air conditioner Lab
- Heat Transfer Lab
- Strength of Material Lab
- MECHATRONICS
- Hyduralic and Pneumatics Lab
- Robotics and Auto Electronics Lab
- Mechatronics System Design Lab
- Mechatronics Lab
- PHYSICS
- SPECIAL PRODUCTS
- Robo
- Crystal Puller
- DCS
- X - Y Table
- Battery Testing
Copy@2005 www.vimicrosystems.com All rights reserved
ROBOTICS TRAINER
- Philips P89C51 Micro controller
- On chip 64k bytes of flash EPROM for program memory
- On chip 1k byte RAM for Temporary program storage
- On board LED provided to visualize power on, transmit data&receive data
- One RS232&RS485 serial port terminated at 9 pin D connector
- In-System flexible programming by Win ISP software
- Serial interface cable to link with PC
Robotic Trainer Controller
Robotic Trainer Software is used to study the Robot characteristics of arm Movement and object pick and place assignment of robot manipulator.It controls the Robot arm movement and measure motor axis and arm axis.‘C’ & ‘Visual Basic’ languages are used to write this software.
Robotic Trainer Software
Arm Configuration - Jointed ARM
Total Axis - Six Axis
Drive - Stepper Motor Drive
Controller - Micro Controller
Gripper - Pneumatics
Application - Pick and Place
Pay Load - 2Kg
Specification
